Multi-axis near-dry Electrical Discharge machining using inconel 718 alloy

ABSTRACT

In the current research work, in-house developed and fabricated multi-axis near-dry Electrical Discharge Machine (near-dry EDM) has been used having different tool positions, i.e. tool electrodes in horizontal position (Case-I) and vertical positions (Case-II) as a novel machining techniques in hard-to-reach places and also to improve the process performance. Design of Experiment tool has been used with three process parameters: voltage, discharge current, and pulse-on-time for experimentation purposes. In order to maximize Material Removal Rate (MRR), it was necessary to compare and enhance these parameters in both cases, i.e. Case-I, and Case-II. The machining process is significantly influenced by the vertical tool positions, as indicated by the largest percentage contribution in the Analysis of Variance results. The voltage has the least influence, while the pulse-on time is relatively less. In contrast, for the horizontal tool position, the voltage proved the most prominent factor in terms of influence, while the current ranked second in significance. Conversely, the pulse-on time exhibited the least impact among the three factors. The highest MRR 2.45 mm³/min was achieved in the vertical tool position while in horizontal machining, the highest MRR 0.144 mm³/min was observed. These findings provide valuable insights into the multi-axis near-dry EDM with proposed methodology.

KEYWORDS:

• Near dry-EDM
• multi-axis
• tool positions
• MRR
• dielectric fluid
• current
• pulse on time
• voltage

Acknowledgments

We would like to acknowledge the Advanced Machining Lab at SGSITS Indore for conducting the experiments.

Disclosure statement

No potential conflict of interest was reported by the author(s).